The camera will give reminders of reset.įor Reolink Keen, it will sound the prompt “Factory reset succeeded”. Press and hold for about 10 seconds, then release it. Insert a pin or needle into the reset hole (as shown in the picture). To quickly reset cameras like Reolink Keen, C1, C2, C1 Pro, and C2 Pro in three steps. How to Reset Reolink Keen, C1, C1 Pro, C2, and C2 ProĪpplies to these models: Reolink Keen/C1/C2/C1 Pro/C2 Pro. The default username is “admin”, and the default password is blank (no password). After reset, your camera will return to factory default settings, then you can log in with the default username and password. Keep holding for about 10 seconds then release the Reset button. Press the Reset button and hold it (don’t release), then power on the camera while pressing the Reset button. Follow the step below to reset your bullet or dome cameras to factory defaults by pressing the Reset button. Keep in mind that the actual interface may vary depending on specific models. ![]() The instructions come from Reolink’s official technical documents, including the pictures. In this guide, we will show the reset procedure for various models of Reolink security cameras such as regular IP cameras, PTZs, WiFi cameras, etc. There are basically two ways to reset the lost password on a Reolink camera: restore it on Reolink software if the camera is still connected to the recorder or, the easy way, press the reset button on the camera and recover the password right away. ![]() If you forgot the password of your Reolink IP security camera, you can perform a hard reset and bring the password and the whole device to factory settings.
0 Comments
Leave a Reply. |